Beretta Grip Screws Slotted Head Kit 92 & 80 Series EU00017

Overview of the Beretta Grip Screws Slotted Head Kit | EU00017

Replace worn grip screws with genuine Beretta hardware

A loose or stripped grip screw turns a reliable duty pistol into a rattle. Grips shift under recoil, panels work loose in the holster, and a chewed-up slot means the next armorer has to fight the part out. The Beretta Grip Screws Slotted Head Kit (MPN: EU00017) puts factory hardware back in the frame so your grip panels sit tight and stay tight.

What you get in the kit

This is a complete four-corner replacement set: 4 Beretta grip screws and 4 washers, all finished in a matte black that blends with standard Beretta slides and frames. The screws use a clean, wide slotted head that seats a flat-blade driver fully across the slot, which is exactly what you want when torquing a small fastener you do not intend to strip.

Officers carrying a 92 on duty, armorers maintaining an agency fleet, and 80 Series owners refreshing a well-used pistol all reach for the same part number here: EU00017.

Key Features

• Genuine Beretta Part: Factory replacement hardware, MPN EU00017, not aftermarket substitute screws.
• Complete Set: 4 grip screws and 4 washers, enough to rebuild all four grip mounting points at once.
• Finish: Matte black, low glare, visually consistent with factory Beretta grip hardware.
• Head Type: Slotted head, driven with a standard flat-blade screwdriver or gunsmithing bit.
• Washers Included: Each screw pairs with a washer, which helps the fastener seat evenly against the grip panel instead of digging in.
• Broad Platform Fit: Serves the Beretta 92 Series and 80 Series families.
• Care Guidance: Snug the screws firmly by hand with a properly fitted flat-blade bit. Do not overtighten, and check them during routine cleaning.

Specifications

Compatibility

The EU00017 kit fits the Beretta 92 Series and the Beretta 80 Series pistol families. Beretta specifically lists the following models: 96A1, 92XI, 92X Compact, 92X Centurion, 92GTS, and 92X Performance.

Limitations to know before you order

These screws are sized for Beretta grip frames. They are not a fit for Beretta polymer-frame platforms such as the APX or Px4 Storm, and they are not intended for non-Beretta pistols. If your pistol wears aftermarket grip panels, confirm the panel maker's screw requirement first, since some custom grips call for their own hardware. When in doubt, match against your existing screws or ask a certified armorer.

Intended Users

Law enforcement officers who carry a Beretta 92 on duty rely on these screws to keep grip panels locked down through long shifts, vehicle work, and holster wear. Department and agency armorers keep the EU00017 kit on the bench because grip screws are a routine consumable during annual inspections and fleet maintenance. Competitive and recreational shooters running a 92X Performance or 92XI use the kit to replace hardware that loosens under high round counts. Collectors and civilian owners restoring an older 80 Series pistol turn to this part to swap out corroded or stripped screws with correct factory hardware.

What's Included

• 4 x Beretta grip screws, matte black, slotted head
• 4 x washers

A flat-blade screwdriver or gunsmithing bit is required for installation and is not included. Grip panels are not included.

Available at WCUniforms

WCUniforms is a veteran and law enforcement family-owned specialty retailer serving law enforcement, corrections, EMS, fire, security, and military professionals. This kit ships from our Michigan warehouse, and our team can help you confirm you are ordering the right part number for your pistol. Unlike general sporting goods sellers, we stock the small maintenance parts that duty professionals actually need to keep gear in service.